Putting Lights In The Attic
Attics often have electrical cabling running through them so an electrician or.
Putting lights in the attic. Use your stud finder to locate any joists that may be in the way. Always cover the tops of the ceiling joists to make sure the insulation is deep enough to reach your target r value and to prevent thermal bridging the heat loss that occurs through the wood framing. You can also make a small hole in the ceiling and insert an un bent coat hanger into the ceiling to feel for any obstructions. Look for a label marked ic inside the can.
Spread fiberglass batt. Place a stepladder under one the lights climb it and remove the bulb. Depending on your attic structure an engineer may recommend the installation of lvls between the existing joists to bring the floor structure up to code. Work from the perimeter of the attic toward the door or hatch so that you don t trample all over the insulation you just put in.
Make sure there are no obstructions in your ceiling as you plan where your lights will be. Install a battery operated light. If you are using incandescent. If wiring a wall.
Attic light and switch wiring kirk because there is power to an existing light fixture in the attic area then the additional light switch and light fixture will be relatively straight forward. Turn off the lights and leave them off for at least 10 minutes before you touch them. How to insulate around can lights 1.